Installation Instructions

1.  Remove the nut from the underside of the pivot bolt



2.  Remove the pivot bolt



3.  Pull back the rubber boot covering the cable adjusting nut



4.  Loosen the locking nut until it meets the head of the adjusting bolt.



5.  Turn the adjusting bolt in (clockwise) until it won't go any farther



6.  Back off the adjusting bolt and ocking nut until the grooves align with the groove in the lever



7.  Slide the cable out of the slot and pull the lever out of the perch



8.  Remove the cable from the lever



9.  Push the pivot bushing out of the lever with your finger, a wooden dowel or a soft tool



10.  Insert the bushing into the Clevver and seat it fully using the same care to prevent damage



11.  Insert the cable into the Clevver as shown.  Make sure the end of the cable is in the seat closest to the pivot



12. Insert the Clevver into the perch being careful to depress the clutch switch button to clear the switch paddle



13.  Insert the pivot bolt, rotating it until it seats and replace the self locking nut. Do not over-tighten



14.  Turn the adjusting bolt out (counter clockwise) untilthere is 1/4 to 3/8"
free play as measured at the end of the lever. Secure in place with locking nut and replace boot

---

Refer to your Owner's Manual for a full description of the cable adjusting and lubrication methods and specifications.

It is possible to increase the free play to bring the friction zone closer to the handlebar grip.  However, it must be kept in mind that the clutch must be fully engaged at least 1/4" before it's outermost limit and fully disengaged before the lever reaches the handlebar grip.